Q. I’m Looking to cover an exterior
entrance door with wood veneer.
I am in NY. Sometimes rain, splash, or snow will get
on the door.
Do you have a suitable wood veneer to cover an
exterior door?
Is there any protective finish that I can apply?
Please advise
ThanksDonA. You can veneer an exterior door, yes…….But: For best
results you should use a waterproof glue, such as Titebond 3, wit…
Q. How can I join my veneer edging strips at the corners to make a 45 degree angle joint?A. Yes, it is possible to make a 45 degree joint with your veneer edging strips. It might take a couple of tries. Use the peel and stick veneer edging strips. The veneer strips should be a little over sized - wider than the area being covered. This allows for trimming after you apply the edging strips.…
Q. I previously purchased
veneer from you, and it's working out great. I'm now looking at changing the
appearance of ceiling beams using your white oak veneer (https://www.veneer-factory-outlet.com/white-oak-veneer-sheets-savings-f-c/). However, I need a length closer to 12 foot. Can
you produce a longer length?Answer:Yes, we can supply our veneer sheets in the
12’ length.Several species are…
Q. Hi, re: 2 ply wood backed veneer - is there a membrane between the wood veneer and the wood backer?Answer - Yes, there is a 10 mil paper back between the wood veneer face veneer and the wood veneer backer veneer.Regards,Bob Morgan, PresVeneer Factory Outlet.comWood Veneer Factory Outlet.com…
Q. Hey Bob, I see you recommend 3 methods to adhere veneer
to a surface, and using a PVA method is
best. I prefer that to contact cement because these are smaller surfaces each
side. I know how to prep the MDF. I have read that you can apply the veneer and
roll, then iron it. When using PVA glue to mount
the veneer, will rolling and/or just adding even weight on top of the veneered
surface b…
Q. I'm veneering panels for
doors, flat, more of less 2 feet square. Should I veneer both sides of the door
panel? If I glue a paper backed veneer or a 2-ply wood
backed veneer onto 1/4 inch plywood, should I veneer the other side? If the veneered panels are “captured”
in the door frame styles and rails, do I still need to veneer the backs of the
panels? Answer. The sh…